How to Install a Shibaura Chainsaw163

Installing a Shibaura chainsaw is a relatively simple process that can be completed in a few steps. By following these instructions, you can ensure that your chainsaw is installed correctly and safely.

Tools You Will Need

Before you begin, you will need to gather the following tools:
Allen wrench
Phillips head screwdriver
Flathead screwdriver
Wrench
Safety glasses
Gloves

Safety Precautions

Before you begin working on your chainsaw, it is important to take the following safety precautions:
Wear safety glasses and gloves at all times.
Make sure that the chainsaw is turned off and unplugged before you begin working on it.
Do not attempt to repair the chainsaw yourself if you are not qualified to do so.

Step-by-Step Instructions

Follow these step-by-step instructions to install your Shibaura chainsaw:
Locate the chain cover on the side of the chainsaw. Use the flathead screwdriver to loosen the screws that hold the chain cover in place.
Remove the chain cover and set it aside.
Locate the chain tensioner on the side of the chainsaw. Use the wrench to loosen the chain tensioner nut.
Place the chain around the guide bar and sprocket. Make sure that the chain is facing the correct direction.
Tighten the chain tensioner nut until the chain is snug. Do not over-tighten the chain tensioner nut.
Replace the chain cover and tighten the screws.
Locate the spark plug on the side of the chainsaw. Use the wrench to remove the spark plug.
Insert the new spark plug into the spark plug hole. Tighten the spark plug using the wrench.
Connect the spark plug wire to the spark plug.
Fill the fuel tank with gasoline. Use a mix of 50:1 gasoline to oil ratio.
Close the fuel tank cap.
Start the chainsaw and allow it to run for a few minutes.
Check the chain tension and adjust it as necessary.

Troubleshooting

If you are having trouble installing your Shibaura chainsaw, here are a few troubleshooting tips:
Make sure that the chain is facing the correct direction.
Make sure that the chain tensioner nut is not over-tightened.
Make sure that the spark plug is properly tightened.
Make sure that the fuel tank is filled with the correct mix of gasoline and oil.
If you are still having problems, consult a qualified mechanic.

2024-11-07

Previous：Where Should You Place a Neck Massager Pillow?

Next：Juicy Watermelon: A Refreshing Summer Treat with Electric Juicers